My mate needs a bare engine for his bmw, getting mad quote off the usuall breakers, anyone on here know where theres one going handy or have any good contacts??? Needs this yesterday.
Thanks.
My mate needs a bare engine for his bmw, getting mad quote off the usuall breakers, anyone on here know where theres one going handy or have any good contacts??? Needs this yesterday.
Thanks.
I know where there's one. I'll give him a shout there to see if he still has it.
He would be able to courier it to you if your very stuck for time too.
I'm guessing the swirl flaps are after making bits of the old engine?
Is it possible to prevent this swirl flappy issue?
Have a 04 320cd!
yes take them out asap!!!!!! my bros car only had 90k miles and the fuckers broke up and destroyed it!!
simple job take off the inlet mani remove all the flaps you will see when you have it off then cut the little rod they are mounted on and pull it out of the holder then tread in a bolt to the hole to blosck it off, leave all the actuator and vacume pipes the same way you took them off so it thinks they are still there, it make absolutly no diffrance wit them gone
it makes no diffrance that you can feel driveing any way lad id say if you put it on a dyno it may have a diffrant tourqe curve from stock, but would you rather leave them there like a ticking bomb to spend 1400euro on a new engine or just pull them out for peace of mind and maybe have a small tourqe loss for posibly 2-300rpm
my bros car is a 04 320cd 150bhp model and late 03 bmw changed the flap desine to bigger stronger ones witch it had fitted! and they still broke off and destroyed the engine it would have needed 4 valves a new head, a new piston, a new block that would be an awful lot of money off bmw as the manifold alone is 470euro+vat trade i got him a second hand engine with 85k on it for 1400euro and removerd the flaps before ftting it
im not arhuaring with the fact of taking them out atal was just courious bout does it make any difference to the driving that u would notice.. ya the newer design stuff never works either thel always keep doin it same as the ford mondeo uses the plastic flaps the they fall off the bar and down into the cylinder .