Lots of shitze needed, you might have them in the back of your shed :D

[DaveM-sport]

5 stud wheel spacers in Toyota fitment. (for my daily)

Have some of those standard 5 spoke jobbies in the garage that came off an is200. there is tyres on them but are probably in shite and I'm sure there's one or two triangles on them!

would like to get rid of them anyway though if you want to give anything for them.

[PeterT]

thanks, but im not looking for any wheels!?

[PeterT]

bing bing boom

[Barnes]

Joe in custom metal works could make ya the piping

[PeterT]

It's only the little rubber one, should have stated that! Ps are u in Vodafone 1c?!

[B&G Extreme Drifting]

any ur mates handy with steel...make up a frame for seat in 1-2hrs fitted the lot....u be doin wel to get 1 for 40-50 were as if u make 1 it'l cost 10-20...is it track car??if not that idea out the window..iv the coil mounts there if u get stuck..did u have look on e-bay at clutches??always a gud bet lad

[Barnes]

Yeah man for my sins
Tis a kip

[PeterT]

Yeh I think I might get a rail made up as u have a bride recliner lying there at home! I'd e a little bit weary buying clutches off the bay!

Barnes, me too, over by the window though so it's not too bad

[twailbait]

Yeh I think I might get a rail made up as u have a bride recliner lying there at home! I'd e a little bit weary buying clutches off the bay!

Barnes, me too, over by the window though so it's not too bad

Just buy a clutch brand that you know and your fine!

[PeterT]

Need a decent make and I've seem on dw there's like fake new exedys and stuff on eBay!