Reversed spilt rims,Safe or Unsafe?

[nikkisixx69]

ya will lad,gone sandblast the centres and either polish or spray white!

polish FTW

[willie 180sx]

polish FTW

ya id say i will lad!loads more sandin to be done!

[lukeworx]

i was tinking of doing my ssr centres the off white pearl of my car
is it hard to break apart & rebuild these rims without having any airleaks?
also is there a special bit/tool to open the nuts?
dont wanna ruin them using a hex/allen key bit & roundn them off etc.

[willie 180sx]

i was tinking of doing my ssr centres the off white pearl of my car
is it hard to break apart & rebuild these rims without having any airleaks?
also is there a special bit/tool to open the nuts?
dont wanna ruin them using a hex/allen key bit & roundn them off etc.

no bother really lad,didnt have to use hen/allen key at all,i just loosened the 12mm nuts on the back and you could hold the front with your hand,usesum wd-40 on the first. then gently tap the centres out with a rubber mallet and it should fall out, make sure to tighten them well when you put them back 2gether tho.

[dil]

no bother really lad,didnt have to use hen/allen key at all,i just loosened the 12mm nuts on the back and you could hold the front with your hand,usesum wd-40 on the first. then gently tap the centres out with a rubber mallet and it should fall out, make sure to tighten them well when you put them back 2gether tho.

do you have to reseal them some way when you put them back together?

[anto180]

how did this go?

[lukeworx]

no bother really lad,didnt have to use hen/allen key at all,i just loosened the 12mm nuts on the back and you could hold the front with your hand,usesum wd-40 on the first. then gently tap the centres out with a rubber mallet and it should fall out, make sure to tighten them well when you put them back 2gether tho.

sound good man handy to know