Follow Us On Follow us on Facebook
Register
Page 5 of 5 FirstFirst ... 345
Results 41 to 47 of 47
  1. #41
    di Member
    Status
    Offline
    User ID
    2268
    Join Date
    Jan 2011
    Posts
    88

    Default

    Quote Originally Posted by danny86 View Post
    head is wrecked lookin at this yoke..

    any one want a job to get this yoke up and driving???
    any luck danny


  2. #42
    di Member danny86's Avatar
    Status
    Offline
    User ID
    357
    Join Date
    Aug 2009
    Location
    westmeath
    Posts
    1,608

    Default

    car wasnt gettin fuel, its gettin fuel now.. and changed CAS still wont start.??


  3. #43
    Skids & Wheelies
    Status
    Offline
    User ID
    1117
    Join Date
    Mar 2010
    Location
    Waterford
    Posts
    512

    Default

    is your loom re located in your wheel arch, if so check for damaged cables. might be even a slight nick and the cable will corrode with bad weather inside in its pvc coating.
    Had similar problem and found my ignition cable had a tiny nick and had corroded inside in its pvc protection.


  4. #44
    di Member danny86's Avatar
    Status
    Offline
    User ID
    357
    Join Date
    Aug 2009
    Location
    westmeath
    Posts
    1,608

    Default

    Quote Originally Posted by sparky View Post
    is your loom re located in your wheel arch, if so check for damaged cables. might be even a slight nick and the cable will corrode with bad weather inside in its pvc coating.
    Had similar problem and found my ignition cable had a tiny nick and had corroded inside in its pvc protection.

    will check that today..thanks


  5. #45
    Pro Driver
    Status
    Offline
    User ID
    9
    Join Date
    May 2009
    Posts
    363

    Default

    have you checked for power at a few places when the key is on? i had a similar problem.check voltage at the cam position sensor,air flow meter and ecu if you had a running one with ya from a friend to see whats supposed to be live would be the handiest.

    Drifting:Because soccer,tennis,football ,hurling etc only require one ball.......

    -Driftireland Perth Rep-

  6. #46

    Exclamation

    i had the exact same problem sorry to say but the , cas , ignition amp sensor , coil loom nd engine loom had all shit them selves , i was stil getting power to ecu starter signal injectors wer pulsing was getting fuel but no spark ur better of getting a loom a loan of 1 if possible and try running it over the wing that picked out all my faults ..... yowdy was the genious that sorted it for me


  7. #47
    di Member
    Status
    Offline
    User ID
    2268
    Join Date
    Jan 2011
    Posts
    88

    Default

    danny. ross here got mine going yipee !!!!!!
    passenger side under dash 2 relays think there blue {colour blind} thick black wire with thin red line there on both relays .splice one of these ok.now on the interior loom to ecu loom at connecter "big white one"again passenger side find ground pulse wire for injectors black wire at end of dash loom to ecu loom there is only 6 to 7 wires on this line of small block splice this wire and join to relay wire and u should fire up. if u find this too hard to understand or have no joy give me a call on 0833121728, best of luck


 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •