Quote Originally Posted by D1SL View Post
great work man keep it up!
cheers man,

well i really wanted to move the Loom as alto it was pulled up over the metal guard the Wheels are so Wide that they where rubbing on the Rubber grommet where the loom enters the cabin, i had the dash pulled out but was too afraid to Go disconnecting the loom incase i break something LOL so after dieing with a hangover all day, i had a couple kopperbergs and at around 9 o clock at night i though fuck it just get it done!!
couple hours later and bobs your uncle Fannys your at Loom Mover never to be in the Way again
ready for surgery



Cabin was in a bit of a state lol



As it started note where the Bonnet release cable is, it was getting eaten by the tyre too


so i disconnected the cable, re routed it through the engine bay and drilled a new hole higher up and connected it back up


Got brave with the 3 1/4 whole saw bit and Drilled a hole for the loom


you can see old hole Vs new hole,


the finished Article



For anyone who wants to do this go for it its a peice of piss!!

this is what you need to Disconnect the cable to the steering colum and the 5 conectors on it


this top connector take the connector at the back of it,


these two connectors on the Fuse board


and another Black plug on the back of the fuse board,


and this big white block connector


then pull out your loom re route and plug back in 2 hour job just need to fill up the two gaping holes now