fitting hydro

[ste]

mine is spliced into the existing line coming from the master cylinder....

[tweek]

@ste you need break the line through the hydro I.e go from the master cylinder to the hydro and out again on to the rear brakes who done yours?

[skinnynphats200]

mine is spliced into the existing line coming from the master cylinder....

No man, just get braided lines and run the line straight from the master cylinder to the hydro and and then from the Hydro straight into the t piece where the existing line goes to the rear brakes

[ste]

but will my car pass the test like this, effectively its doing away with the factory line isnt it

[skinnynphats200]

but will my car pass the test like this, effectively its doing away with the factory line isnt it

It would be more likely not to pass the test imo with a line spliced into the original one. Your just replacing the line with another one and once its tidy inside as well and the original handbrake is still there, you should have no problem passing the test...

[ste]

who's the best and cheapest place to get braided lines made up so i can get it workin properly

[Chuck_g]

I just splice into the existing lines also..........sorted

[ste]

I just splice into the existing lines also..........sorted

why the fuck is mine shit

[skinnynphats200]

who's the best and cheapest place to get braided lines made up so i can get it workin properly

Get onto driftworks man, there lines are good and can have them here to ya fairly quick as well

[skinnynphats200]

why the fuck is mine shit

Could be the cylinder, did you buy new or second hand? Or else spend a couple of hours bleeding