4 altezza wheels

[cobcorsa]

as long as the conversion is 114.3x5 i dont see why not

[rburns07]

as long as the conversion is 114.3x5 i dont see why not

i wil check later on and tel u!

[R32slider]

toyota and nissan are both 5x114.3 but the thread pattern is different and altezza wheels are held on by a sort of lug nut with a lip on them that fit into the wheel, theas nuts wont thread onto the nissan stubs, also the centre of the altezza wheel is smaller than the nissan, we ran into this problem before, the only way out is to grind off the lip around the centre of your hubs and try and get your hands on some oldschool nissan nuts, ie bluebird or something from the late 80's. these are the same shape as toyota's,
hope this helps,

[rburns07]

yea thats helpfull surely m8..ya c i have toyota wheels here and the same story centres dont fit i sent them 2 a boy and got a few mil of the entre and stil dont fit wud h8 2 go 2 much incase wheel weakens!!yano!!

[R32slider]

yeah i wouldnt go takin to much off and in fairnes theres a few mil in the difference, what we did was get 25mil bolt on spacers and cut the center lip off, this helps too cause tezza wheels have shit poor offset so brought them out abit and just take all off then for nice wide nissan wheel, win win,