Cutting carbon for fitting bonnet Pins

[Scamper]

Got these today, and want to know what is the best way to make the holes in the Carbon bonnet to fit them, any particular way or methods of doing it. Is carbon hard to cut or drill, does it flake, crack etc...



Any help appreciated

Scamper

[johnbro]

I'd wear goggles and a dust mask anyway to be safe
The stuff can be dangerous if you breathe it or it gets in your eyes

I've an old carbon bonnet was goin to make up a center console from it
don't know what it's like to cut

[subzero]

thread on DW about it ... youll need a drimmel type cutter.... tape the bonnet very well to save the lacquer cracking.

[benhachi]

i fitted them to mk1190s glanza years ago taped up the shape to be cut drillred a hole then as above used a dremmel to bore it out! usually get different grades of abrasive with them so dont go too rough! put masking tape over and drill through it for the small hols for screwin them down!
be very careful cause once its cut its cut so line everything up before you even attempt drilling!

[ger15]

Scamper you should get someone that knows what there at in fairness you havnt hands to butter bread,and if you go to big cutting out the shape you can't patch it up

[Scamper]

Funny man ger, im not going cutting it myself, i just wanna know how it is done!