brake pad retaining pin wirey spring thingy

[thegosson]

packing up at mondello yesterday. i noticed that the little wire springy thing that goes into the hole on each brake pad retaining pin was missing on one of the rear calipers and the pins were hanging in by the skin of there teeth. so i need one of these if anyone has one knocking around. my calipers are off a z32 but im pretty sure an r32 or r33 or s14 or s15 one would do as i think there the same, but open to correction.
its the yolk marked number 8 on this diagram in case your not sure what im on about.

[galhal87]

You should get replacements with a new set of pads lad.

[thegosson]

iv projeck mu pads and there was none with them. but if what you say is right then there must be an abundance of the things out there

[mo_yassin]

You should get replacements with a new set of pads lad.

Never seen this myself...

Just stick a split pin in the hole of each retaining pin. Should do the job.

[galhal87]

Have never seen them come with aftermarket pads, i have often got them with spurious pads from the motor factors tho.

[thegosson]

Never seen this myself...

Just stick a split pin in the hole of each retaining pin. Should do the job.

had thought of that alright but im a bit of a stickler for doing things right. but that will be the last resort.

[thegosson]

come on lads somebody must have one of these lil bastards lying about

[Mick K]

Shane Ive needed parts 1,7,8 and 10 for the last 2 months and only picked up 1 side last friday,Still need another side,REALLY hard to come by,Should you get the option to buy both sides take em on and I'll take all bits you dont need!

[thegosson]

come on boys and girls get rooting round for one of these yolks an help me out

[Driftma]

This might sound mad,but would ya not just go into nissan for one?