engine rebuild parts help

[Drift_sil80]

well i got these bits and i think thats the top end sorted so i just want to see what would ye suggest to do to the bottom end??

Tomei 173019 M7960 ARMS Turbo Kit

Brian Crower Cams & Valve Springs & Retainers Kit Stage 3 S13 SR20DET

Brian Crower CNC Stainless Steel Intake & Exhaust Valves SR20DET +1.0mm

Tomei 13220R300 Rocker Arm Stoppers (RAS) SR20DET

Apexi 814-N102 (86mm x 1.1mm) Metal Head Gasket SR20DET S13 S14 S15

ARP 204-4204 Engine Head Studs Bolts Kit Nissan SR20DET RWD


i got those few bits and i was tinking of getting tis to finish it off
Brian Crower BC0209 2.3L SR20DET Stroker Kit

but would it all be compatable and would it be ak wit a apexi pfc and z32 afm and 550 sard injectors?

[RedlineKits]

get some race bearings for it anyway lad.. make a mad differnce to reliability

[Baz_180]

Your not sparing the money on this rebulid!

I would imagin if you put in the stoker kit that you would need bigger injectors because you must be going for big power

[colm]

bigger injectors.
Bigger turbo.

What size pistons does the stroker kit use? That head gaskets for a standard bore

[alan opel]

have you had youre block checked? as said that gasket is for standard bore. might have been worth goin for and over bore depending on your bore wear

[jamie180sx]

firstly,
i would use acl race bearings,
if you have or can get a s15 crank,
I would highly recommend a Gti-r(rn114)oil pump conversion
the bc stroker kit is a nice bit of kit,and with a 2.3 engine you will have nice torque,but if i was building it i would build a 2.2 engine,using oversize pistons(90mm pistons)by using a short stroke engine you will gain a revier engine,the stroker engine dont like to rev.The 2.2 engine have been known to produce higher hp than the stroker engines.(if you need more info on these drop me a pm as we have done quite a few 90mm engine with great results,and can direct you in the right way)
i would also say the tomei turbo will be to small if you running a stroker engine,and the headgasket you ordered is only for a std bore,so will need a bigger 1