omori water temp rad hose insert

have this for sale as the sensor from my new water temp gauge is too narrow so its no use to me.....

the diameter of the insert is roughly 38mm or so so will fit perfectly in most rad hoses

€15

0863242430

http://i55.tinypic.com/34jf349.jpg

will this fit the defi screw in probe??

most likely man as i tried my greddy oil temp probe and that threaded in if ya can measure the width of the threaded part of probe i can measure it here for u

be handy if i had a vernier hmmm any ideas? will fit an sr20 rad pipe yeh?

ye i just took it out of a 180 rad pipe last night and fitted a new adaptor for the gauge i going to use

il take that if its a 3/8 npt

has no visible size markings jimmy

my probe thread is 10mm id say it will fit ?

I meān the diameter of the thread nut

yeh if your female thread that the probe screws into is around 10mm id should do

heres a pic of the nut that is asttacted to the probe and that screws into hose insert....

its 14 or 15mm i wank too much so eyesight not the best lol

http://i51.tinypic.com/33xk5s7.jpg

the inside of that nut is threaded aswell yeh? think thats the 10mm im looking for

no man the insert of the nut is a smooth sleeve, sounds like u have same issue i had thats why i had to but a different insert

il take it off ya man could meet ya in swords

bump...

only seen reply now deco text me if still want it 0863242430