s14 project :)

next lined up the wings with the front bumper

http://i200.photobucket.com/albums/a...ABCD0007-8.jpg

and the bonnet and the other wing lined up

http://i200.photobucket.com/albums/a...ABCD0012-7.jpg

looking good so far

done

http://i200.photobucket.com/albums/a...8042009738.jpg

http://i200.photobucket.com/albums/a...8042009739.jpg

http://i200.photobucket.com/albums/a...8042009742.jpg

me and one of the lads did it in 4 hours!! only few small bits left to do like washers on bonnet and need few on drivers side headlight and bolt on front bumper properly

going for paint in 2weeks!!

small thing here!!
have bonnet pins but not sure if i want to put them on really!!

so got double sided tape and put them up against it

with

http://i200.photobucket.com/albums/a...ABCD0017-8.jpg

http://i200.photobucket.com/albums/a...ABCD0018-9.jpg

without

http://i200.photobucket.com/albums/a...BCD0019-11.jpg

and here the spec as it stands at the min

S15 Spec R engine
TRUST T518Z TURBO(10cm exhaust housing)
respray in pearl grey metallic with gold metalflake
Enkei racing ABC Exclusive front alloys 17x9.5J with new 235/40/17 toyo proxies T1R's
Rays Engineering Pleasure Lictrix rear alloys 18x11J with new 265/35/18 federal 595's
Front Mount Intercooler
apexi induction kit
Koyo Rad
Cusco 2 way lsd
HKS 555cc injectors
Apexi boost Gauge
Full Exhaust System
Downpipe
Decat
Tomei turbo elbow
Tomei manifold
Trust adj actuator
Silicone Rad Hose
Kei-Office Full adj Coilovers Camber Adj Top Mounts
ORC Clutch
Flared Arches
Full VIP Kit made by JC Fibreglass in Japan (very Rare)
Cusco Front and Rear Strut Braces
2 Bride Recliner seats
Sparco deep dish steering wheel
kouki rear lights
Nismo Shift Knob
silvia gear gaitor
Drift Handbrake Button
Greddy Temp Gauge
Greddy turbo timer
braided oil line
cosmo rad cap
uprated gearbox mounts
Walbro Fuel Pump
apexi power fc + commander
greedy profec B- Spec II boost controller
rocker cover resprayed blue
z32 afm
D2 Harness
Back stripped out and sprayed black

This car is damn hot, makes me more and more jealous everytime i see it!

What power did you get out of that turbo?
Its the next one up from mine but from what i can see it wont fit with my manifold as at the mo my T157 is nearly resting against the engine mount!
any more pics of the mani and turbo in place??

[QUOTE=Jay;955]This car is damn hot
QUOTE]

+1

Quote:

---

Originally Posted by Jay

This car is damn hot, makes me more and more jealous everytime i see it!

What power did you get out of that turbo?
Its the next one up from mine but from what i can see it wont fit with my manifold as at the mo my T157 is nearly resting against the engine mount!
any more pics of the mani and turbo in place??

---

havent had it dyno's now since the new turbo went in!! will be doing it during the summer but will deffo be 350bhp+ as iv a few other bits going in..

these the only pics i have of it at the min!!

http://i200.photobucket.com/albums/a...ABCD0001-7.jpg

http://i200.photobucket.com/albums/a...ABCD0002-6.jpg

can take a few if needed

Hmm, can ya see if your exhaust housing is near your engine mount??
Mine touching! could be the different manifolds..

I'm getting mild cams, increasing boost and a remap soon so hoping to get 350bhp(ish) aswel with loads torque!

Not that i'm copying, haha:D

What boost & power you running at the mo?

is it me or would that car be soo cool to just drive about in and look pimp :)

its looking well !

Quote:

---

Originally Posted by Jay

Hmm, can ya see if your exhaust housing is near your engine mount??
Mine touching! could be the different manifolds..

I'm getting mild cams, increasing boost and a remap soon so hoping to get 350bhp(ish) aswel with loads torque!

Not that i'm copying, haha:D

What boost & power you running at the mo?

---

il check when it drys up!! pissing rain

im running .9 - 1bar at the min so power wise its be a guess but 300+ i say!! last dyno was with hks turbo with 308bhp and 368ft/lb of torque

Jesus thats good torque! are ya gona do a few drift days with it?

Next ones a week away, DO IT!!!