Very nice project man. A lot of very tidy work gone into. Best of luck with it, will be a very nice Kp
Printable View
Very nice project man. A lot of very tidy work gone into. Best of luck with it, will be a very nice Kp
love kp's , fair play on all the work looking forward to the finish project!!
Good luck with the rest of the project :)
Serious fabricating man. Cant wait to see more:)
Only seing this now , didnt think ya where that far along with it Marty .
Tidy fab work man :cool:
Going to be a serious machine :afro:
Serious work man, best of luck with the rest of the build
just wondering y didnt you run a live axle outa a lite ace or vanet ,it just looks like your mounting points for back supframe are going to fairly close to the ground clearence could be a issue ??
thanks everybody for the comments
a few reasons , half shafts getting hard to come by now as most people that had wee vans at the back of the house weighed them in for scrap,, had all the nissan stuff there,, brakes , load of diffs and adj arms, mounting points are about 15mm lower than the original ones for the live axle so there will be no clearance problems,,Quote:
Originally Posted by feeker75
aright did u have her rolling yet ? wat r you going to do with the front ?Quote:
Originally Posted by martycturbo
another wee bit done on this,, sr and box in,, gearbox mount to make up and firewall to finish and thats all the fab work done, down to bodywork then,, 16 a bit too big on rear,, prob go 4 stud and run 15s instead
http://i847.photobucket.com/albums/a...o/DSC02081.jpg
http://i847.photobucket.com/albums/a...o/DSC02084.jpg