mint 180 lad,really clean and simple kouki!
Printable View
mint 180 lad,really clean and simple kouki!
Thinkin of ultralite nurbergrings, somethin wit dish or else rota grids, sit it lower an plenty of camber :)Quote:
Originally Posted by rob_180sx
i really really like that, very simple and spotless looking. interior looks clean aswell!
Hey, haven't updated my thread n a long time so its time for an update :) I've done a couple of bits with the car, new wheels, poly bushings, under sealed, and other small bits an bobs.
I ment to post up the spec list of the car ages so this is the spec of it wen I bought it back n feb 2011.
Spec:
17" staggered works vs wheels
Gab coilovers
Trust front mount
HKS intake pipe an filter
HKS actuator
Kakimoto downpipe + cat back
5ziegen decat
FMIC
Blitz ID
Blitz boost gauge
Blitz boost controller
Razo gearknob
Razo short shift
Momo steering wheel
Recaro drivers seat
Mapped by westward engineering at 274bhp on standard t25 turbo
Walbro fuel pump
Standard diff.
lovely car love the oem look
1 of the first things I got for the car were Driftworks tension rods. The bushes n the original arms were well worn so time for upgrade. I also picked up a rear subframe fitted wit Driftworks poly bushings, was changing the diff as well so threw the lot n.
http://i1239.photobucket.com/albums/.../Photo0068.jpg
http://i1239.photobucket.com/albums/.../Photo0057.jpg
Sourced a cusco 2 way diff that came out of an s14, only prob was the casing didn't hav an abs sensor like mine so decided to take out the abs entirely!
Bought a roll of copper brake line and fittings for the job. It was straight forward enough, only took a couple of hrs, pulled out the big lump of an abs pump an made up new pipin n the front of the car.
http://i1239.photobucket.com/albums/.../Photo0105.jpg
Also removed all the aircon.
Nice job man. Car is luuuurvly!
need mre pic's hey . . . look'n very well l.week wen i seen it. get a roof spoiler yet ?
Will it still pass NCT without ABS??
I had a Problem before where I had the ABS fuesd pulled out ( forgot to but it back in before test) went in for test and failed because the little light never came on in ignition on turn off after 3 seconds.they say if it came from the factory with it, than it must have it on it for test .
soooooo nice and clean