I'm thinking of going looking at an 180sx with fucked bottom end bearings..would it cost much to put it right? it'll probably need a crankshaft cause the lad that owns it isn't the smartest and probably drove it for a bit with the bearings gone:(
Printable View
I'm thinking of going looking at an 180sx with fucked bottom end bearings..would it cost much to put it right? it'll probably need a crankshaft cause the lad that owns it isn't the smartest and probably drove it for a bit with the bearings gone:(
may need rods aswell new bearings are around €200 .
you wil prob def need a crank lad all the bearings not to sure bout the rods do spose it all depend on how bad the crank is.
sold an engine 2 weeks back without head mint blosk an freshly rebuilt bottom end if only you new bout dis car sooner agh.............:mad:
It would need to be inspected to see exactly what damage is done.
Usually, a regrind of the crank, some new main/big end bearings and thrust washers would usually sort it.
There would be no point doing the above without a new set of rings and give the block a hone anf flush etc.
See here for an idea of whats involved...
http://www.inoc.ie/forum/showthread.php?t=765
Need to reg to see it:mad:Quote:
Originally Posted by nissan_doctor
Doh!:rolleyes: