I have a trueno shell here that i was building up but my plans have changed so it needs to go....
1986 trueno vrt'd
Shell is fully seem welded inside and out
Undearneath sealed and wax oiled so everything is nice a clean undearneath
Engine bag is flushed..ie all unessary holes have been welded only what holes were necessary to keep were keeped
Shell is very decent and is good and straight.
THE SHELL WILL COME WITH THE FOLLOWING
Door's
rear bumper
rear lights and number plate lights
boot door with trd spoiler
fuel and brake lines
dash and loom
boot
flared arches
run free skirts
flared front wings
headlights and side lights
front atiroll bar,tension rods,brackets,
door cards
mirrors
all glass ect as pictured
door locks,petrol flap cables,rear boot door cables rear light loom
Front panel is cut for the ease off engines in and out
i have done some repair work on the shell..It needed small repairs wear the lock sits on both sides,and a small repair on the sill under the driverside door hinge ..These will require paint along with the engine bay and the inside as both were being preped for paint......It needs 2 more minor repairs in the boot..The pockets were past it on the bottoms and have been cut out...the shell is not mint but its very decent...It a small bit off more work to be rust free and some paint and this could make a very nice car again....Thats about as honest as i can be..
price 1500
http://i1153.photobucket.com/albums/...00620306_n.jpg
http://i1153.photobucket.com/albums/...81124724_n.jpg
http://i1153.photobucket.com/albums/...23449429_n.jpg
