Printable View
Went about fitting a cased diff i got last night and found it did nt fit my sub-frame, I thought i d be able to swap the backplates over but they don t fit across. I was going to get a sub-frame out of a turbo car and bolt it in instead.
I m wondering will all the arms from my N/A bolt across to the turbo sub-frame or am i just totally over complicating everything?
Cheers for any advice. :)
is it a 2 way or just normal im the other way around i got a 4-1 diff from an n/a auto and want to put it in my turbo one was told it would fit not looking like it nowQuote:
Originally Posted by diggerdolan
trying to put a 2way from a turbo into my n/a.
could always recase the new diff into your original case?Quote:
Originally Posted by diggerdolan
had to do this to my 2 way recently, seems like it might just be a less complicated option?
Your arms and hubs etc will swap over fine, the rear subframes are the same between turbo and non turbos except for the rear diff mounting points which are closer together iirc on a nonturbo..
Just weld the non turbo diff!! Should be a decent ratio..
i the diff thats in it is smaller,its a r180 diff,rather than a r200 diff,,,i have a 2 way diff fully cased with a 4.1 cwp ,for sale unreal diff infact the best diff ive every used,
thats strange as i put a 2way into mine fron a turbo & all i had to do was swap the plates,
easiest option there would be to weld the standard 1 !
What did you get the diff from??Quote:
Originally Posted by andy t
I would weld the diff but i wanted a better ratio and i ve the 2 way bought so no point in letting it go to waist!
bring it back :) and get the right one for u car. :)