PS13 Clutch Problem??

Printable View

20-10-10, 09:56
mcdae86

PS13 Clutch Problem??

well, have ps13 with sr20, when i got it was told there was new exedy cluth in it, it bites within in inch of the floor. it perfect but sometimes its impossible to get into gear, if you pump twice or 3 times it'll go in perfect. just wondering would bearing be on its last legs?? i've bled it and it still the same.. no whining or any noise from gearbox.. any ideas?? thanks ;)
20-10-10, 10:08
Bobbys14

Quote:

Originally Posted by mcdae86

well, have ps13 with sr20, when i got it was told there was new exedy cluth in it, it bites within in inch of the floor. it perfect but sometimes its impossible to get into gear, if you pump twice or 3 times it'll go in perfect. just wondering would bearing be on its last legs?? i've bled it and it still the same.. no whining or any noise from gearbox.. any ideas?? thanks ;)

Had the same problem, i ran a braided line from the cyclinder to the piston to bypas the damper, bleed it and then adjusted the pedal inside the car to take the bit of play out of it.. Now 100%
20-10-10, 10:18
mcdae86

cheers, was it complicated job??
20-10-10, 13:43
burner

ive seen some lads just carefully bend the pipe from the cylinder to the damper and fit it direct to the piston and just dump the damper altogether thats if you want the cheap option.
20-10-10, 15:00
Bobbys14

Quote:

Originally Posted by burner

ive seen some lads just carefully bend the pipe from the cylinder to the damper and fit it direct to the piston and just dump the damper altogether thats if you want the cheap option.

This wont work tyred it and it dosen't seal properly because the thread aint long enough.. Braided line its handy done.
20-10-10, 18:33
burner

my mistake....cheers, saves me the headache too
20-10-10, 18:58
mcdae86

cheers lads will try get one done up!