View Full Version : Rear camber toe traction rods s14a
As above, no xspower they shit fitted new camber arms and one bent on the first spin :mad:
rowaner2002
03-07-10, 17:05
first spin as in ya hit the wheel and the arm bent?:confused: think most arms would bend if ya hit them
sure buy cheap ones incase it happens again :D
first spin as in ya hit the wheel and the arm bent?:confused: think most arms would bend if ya hit them
sure buy cheap ones incase it happens again :D
No i fitted them done some adjustment went for a drive up the road and when i hit boost d ass wobbled a bit and when i came back seen it was bent:mad:
Just get the driftworks set dude iv them in mine and there perfect. And if you get the camber kit your prob goin to need toe arms too.
Just get the driftworks set dude iv them in mine and there perfect. And if you get the camber kit your prob goin to need toe arms too.
Seeing if some1 here has a set first i need the d rear arm's toe traction and camber! Driftwork's arm's are expensive i know there good thou..
Seeing if some1 here has a set first i need the d rear arm's toe traction and camber! Driftwork's arm's are expensive i know there good thou..
The drift works ones are not that very dear really you can buy the 4 arm kit for about 350 euro i think
The drift works ones are not that very dear really you can buy the 4 arm kit for about 350 euro i think
Where on the site it would work out about 470 to the door
http://www.driftworks.com/shop/p367/Driftworks-S14-Four-Arm-Kit/product_info.html
JUST buy the DW ones !!!! u wont look back !!!!!!
JUST buy the DW ones !!!! u wont look back !!!!!!
Near €500 i dont think so chris not at the mo anyway want to get the car on the road and i need the arms get them setup, get it mapped, tax it and insure it that will sum up to a lot!
Near €500 i dont think so chris not at the mo anyway want to get the car on the road and i need the arms get them setup, get it mapped, tax it and insure it that will sum up to a lot!
If money is tight ,all you really need is the camber arms.
The standard toe arms should have enough adjustment in them anyway.
You don't need the traction arms but the camber and toe are needed! The standard toe arms have no adjustment in them at all. Buy the dw ones and you won't have anymore bending issues
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.