PDA

View Full Version : trying to get wheels to fit



cooks86
31-01-14, 02:56
Iv got pair of ssr viennas 18x9 et 24 for my s14 there 4 and 5 stud tried em on turns out needed at least 15mm spacer to clear front brake calipers so i had 20mm bolt ons so tried them but the original studs are stickin out past space and there is no spaces on the wheel so it wont sit flush against spacer. Dose this mean i have to go 25mm because even with 20mm wheels are fairly far out past arch no camber ??? What to do

Dori_Rory
31-01-14, 08:17
Put a 5 mm floating spacer between the hub and bolt on spacer and see if that solves it. You could always just bolt on the 20mm spacer and take a hacksaw to the bits of the studs sticking out past the spacer

Madmc
31-01-14, 08:21
Sounds like there not he original studs on your hub, some one probably changed them before, becuase i had the opposite problem when fitting 20mm spacers the original studs wern't long enough. You could always cut back the studs to just below the spacer so it will sit flush. Or else mesure the studs and get shorter ones.

cooks86
31-01-14, 09:18
Thanks lads ya dori didnt think of putting the spacer idea

Driftma
31-01-14, 10:59
Its 25mm spacers sit flush with the em studs

cooks86
31-01-14, 23:29
Have ya any for sale marty