Ryan200sx
10-05-09, 18:08
hi all!i am putting my 200sx up for sale!here is the specs
engine and drivetrain
-bottom end has been rebuilt with new stronger bottom end bearings etc
-t28 turbo with braided turbo hoses
-brand new front mount intercooler
-airfilter
-3" exhaust system with 3"downpipe
-walbro fuel pump
-stage 2 chip
-brand new exedy race clutch (never drifted on still being wore in) cost 350 pounds with recipt to prove
-oil sandwhich plate
-manual boost controler
-welded diff
-brand new race battery
-uprated raditor cap
brakes and suspension
-d2 coilovers with adjustable top mounts
-s14 brakes
-brand new driftworks solid steering bush
-brand new 20mm longer wheel studs and 25mm spacers all round
-brand new extra lock washers
exterior
-16" dished wheels 8" wide with a good offset
interior
-fully stripped including sound deadning and resprayed black
-bucket seats
-oil temp, oil pressure and water temp gauge with sensor
-sleepy eye kit
-rear strut brace
car is running about 280-300bhp atm so is a very capeable drift!
only problem is that acid has been splashed over the bonnet and side of the car(not really noticable on the track)
i need 2300 pound for the car which is a very cheap drift car for the spec
can be seen drifting at nutts on the 22nd august :D
thanks for looking
http://s600.photobucket.com/albums/tt85/rmuldrew_2009/
engine and drivetrain
-bottom end has been rebuilt with new stronger bottom end bearings etc
-t28 turbo with braided turbo hoses
-brand new front mount intercooler
-airfilter
-3" exhaust system with 3"downpipe
-walbro fuel pump
-stage 2 chip
-brand new exedy race clutch (never drifted on still being wore in) cost 350 pounds with recipt to prove
-oil sandwhich plate
-manual boost controler
-welded diff
-brand new race battery
-uprated raditor cap
brakes and suspension
-d2 coilovers with adjustable top mounts
-s14 brakes
-brand new driftworks solid steering bush
-brand new 20mm longer wheel studs and 25mm spacers all round
-brand new extra lock washers
exterior
-16" dished wheels 8" wide with a good offset
interior
-fully stripped including sound deadning and resprayed black
-bucket seats
-oil temp, oil pressure and water temp gauge with sensor
-sleepy eye kit
-rear strut brace
car is running about 280-300bhp atm so is a very capeable drift!
only problem is that acid has been splashed over the bonnet and side of the car(not really noticable on the track)
i need 2300 pound for the car which is a very cheap drift car for the spec
can be seen drifting at nutts on the 22nd august :D
thanks for looking
http://s600.photobucket.com/albums/tt85/rmuldrew_2009/