PDA

View Full Version : 180sx wrecker..



Stevo
09-12-12, 19:56
Picked this up a few weeks ago. Most will know it from mondello over the years but its been sat up for near two years..

1994 Nissan 180sx
Blacktop SR20DET
Standard turbo
HKS FMIC
3" Elbow (fucked)
Standard Downpipe
Decat
Blitz Nur spec catback
Engine damper
Strut brace
Exeddy clutch

BRAKES/SUSPENSION/DRIVE
Tein coilovers front and rear
Skyline brakes front and rear disks re-drilled to four stud
Cusco 2 way diff


EXTERIOR/BODY
Uras front bumper
Kouki rear spoiler
HID's

INTERIOR
Full 6 point through dash cusco bolt in cage
Recaro Bucket seat
Schroth harness
Hydro with DW lines
Genuine OMP dished wheel and boss kit
Nismo shifter
Fire extinguisher


WHEELS
17" ADVAN RG's


http://i47.tinypic.com/34domfk.jpg

http://i50.tinypic.com/161fcq1.jpg

http://i45.tinypic.com/24ec4yo.jpg

http://i49.tinypic.com/oji0y8.jpg

http://i47.tinypic.com/x54nix.jpg

http://i45.tinypic.com/10crsck.jpg

http://i50.tinypic.com/2jfdrut.jpg

http://i46.tinypic.com/jt6jpe.jpg

http://i49.tinypic.com/2q1bb80.jpg

http://i45.tinypic.com/okn32u.jpg

Stevo
09-12-12, 20:09
Have a good few bits still around the place from the last 180 so ill get everything fitted by january with any luck..

Only putting this together for practice days and driftfest superdrift ect.

Been tipping away at it since i picked it up.

GTR fuel pump fitted

70mm alloy rad (near 7 fucking liters of coolant in it)

Picked up two sets of wheels, 17"Rota D1's and 17" Arrow enterprise gewalts

Sold off the advan rg's

Bit of rear quarter bashing done on it

Have bomex skirts and brand new uras rear bumper for it aswell..

Gaskets where all fucked on it so we went at them, elbow was cracked aswell so mid taking it off it sheared two studs so got bit pissed off a pulled everything back out and swapped mani ect onto a spare bb turbo..

Fitted a T28R new gaskets and silkroad elbow and downpipe.

Picked up a sweet set of shiny new braided lines, and a non hicas rear subframe off jay @ DI motorsport gent to deal with!!

Car is now has S14 top rad housing and back water feed blanked to make things easier if ive to change turbo again.

Also picked up 30mm Rear quarters off sean (the gewalts also) another gent to deal with!

Picked up some mobil1 off bart to go with the new plugs and filter

Have brand new rear suspension arms for the back aswell, just need front castor arms and swap over subframes and track it up.

Heat wrapping on split intercooler hoses lol, all tidied up now

Have a blitz dual sbc boost controller there for it aswell


Gewalts
http://i46.tinypic.com/34j1xfb.jpg

Quarters
http://i48.tinypic.com/14n1hnc.jpg


Parked up with its new room mates
http://i50.tinypic.com/rm92rn.jpg

seanie R.33
09-12-12, 21:06
nice collection of parts already,you'l have good fun in her!

mini180sx
06-01-13, 02:00
That garage is start in to fill up

Stevo
06-01-13, 02:01
That garage is start in to fill up

lol just abit :p