View Full Version : sr20det helicoil oil feed
does any1 no the helicoil size for the oil feed bolt on a sr20det
Im 99% sure its m12 x 1.5
On the block ya ?
Il double check when im st the garage ive the kit there from when i did mine
robbie@tdp.ie
13-06-12, 13:28
does any1 no the helicoil size for the oil feed bolt on a sr20det
Unless you have the block out and stripped its a recipe for disaster as you will never get it clean enough and the swarf will make its way to the turbo and kill it.
Dont recommend it at all.
Robbie
Ive done it and had no issues. Obviously an oil change straight after and i flushed it through. You will be needing a right angle drill chuck
iv the engine out on a stand anyway its just a spare engine i have lying there myt aswell get sum usee outta it .... do u have 1 pinny
Sorry for hijacking japman,
@ pinny, where can I buy the heilcoil kit? Who sells them? Handy to have around.
Dunnedriftin
13-06-12, 18:49
Unless you have the block out and stripped its a recipe for disaster as you will never get it clean enough and the swarf will make its way to the turbo and kill it.
Dont recommend it at all.
Robbie
X2
robbie is 100% lad!! Also the Wurth time lock system is a much better job than heli-coil... its about €140 for a specific set (ie. 10x1.25 only) but its worth it!
Its m12x1.25 lad. Real cunt ta get local.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.