PDA

View Full Version : Rota gtr's



Paudie
28-07-11, 10:34
Getting a set of rota gtr's for my 180sx just want to know what width and offset would I need.

bart
28-07-11, 10:40
have you standard wings and rear over fenders?

Paudie
28-07-11, 13:03
Ya all standard

skinnynphats200
28-07-11, 13:05
A 17 X 9 should fit grand with a small flare

Paudie
28-07-11, 13:29
what off set should i go for?

skinnynphats200
28-07-11, 17:13
I put a 17 X 10 et 12 on the rear of my 32 with standard arches just rollled/small flare and they fit not a bother...

The 17 X 9s only come in et25

stevokr32
01-08-11, 10:33
i had et35 on my r32 they were 18 x 9.5 front and back.arches needed to be a little bit of rolling. i had a 225 front and rear with a stretch tyre.but id try a go as bit bigger to save kerbage.

rico180
24-09-11, 19:21
make sure you get the dished in type. i had 17x9 et25(25mm spacer on back) and they were just about enough on my wide arch 180, so you might have to roll your wings.

jap scrap
25-09-11, 22:09
Go for et 12 on a 17 x 9j rim will look good with the car droped on them

Johnie
26-09-11, 16:54
It depends on how much camber you have, how low the car is and weather you want to roll your arches or not. I have 17x9.5 et 26 on the back of my car and it was fine with standard arches with the lip rolled, until I straightened the camber then I had to roll the arches out.