stupid clutch need some help here

[johnjoeae86]

right lads bleed the clutch in the 180 all was grand for about a half hour the hit the floor and only a tiny bit of pressure bled it twice again after this and same story changed the master cylnder and still no joy any ideas of what else it could be or did any 1 else have this problem??

[2tonne]

Whats the fluid level like when it starts hitting the floor again after bleeding? Sounds like a leak somewhere most likely at slave, if not that, is the clutch itself and fork moving/working freely?

[Mac_C]

Try bleeding it as normal and with the clutch to the floor and the nipple open detach the linkage from the push rod and compress the piston fully back with your hand and tighten nipple again .

Should sort it .

Failing that you have a leek . :)