View Full Version : For Sale: omori water temp rad hose insert
have this for sale as the sensor from my new water temp gauge is too narrow so its no use to me.....
the diameter of the insert is roughly 38mm or so so will fit perfectly in most rad hoses
€15
0863242430
http://i55.tinypic.com/34jf349.jpg
bounceae86
13-05-11, 21:46
will this fit the defi screw in probe??
most likely man as i tried my greddy oil temp probe and that threaded in if ya can measure the width of the threaded part of probe i can measure it here for u
bounceae86
13-05-11, 21:53
be handy if i had a vernier hmmm any ideas? will fit an sr20 rad pipe yeh?
ye i just took it out of a 180 rad pipe last night and fitted a new adaptor for the gauge i going to use
il take that if its a 3/8 npt
has no visible size markings jimmy
bounceae86
14-05-11, 06:28
my probe thread is 10mm id say it will fit ?
I meān the diameter of the thread nut
bounceae86
14-05-11, 07:13
yeh if your female thread that the probe screws into is around 10mm id should do
heres a pic of the nut that is asttacted to the probe and that screws into hose insert....
its 14 or 15mm i wank too much so eyesight not the best lol
http://i51.tinypic.com/33xk5s7.jpg
bounceae86
14-05-11, 08:05
the inside of that nut is threaded aswell yeh? think thats the 10mm im looking for
no man the insert of the nut is a smooth sleeve, sounds like u have same issue i had thats why i had to but a different insert
il take it off ya man could meet ya in swords
bump...
only seen reply now deco text me if still want it 0863242430
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.